Digital LG plus Series Guia de Configuração descarregar pdf (Página 154)

154

Chapter 7 Using the RibbonMinder

RibbonMinder Fault

By pressing the CLEAR key, you clear the fault which will allow the printer to

continue printing for an additional two minutes. This allows you to complete a

nearly finished print job before changing the ribbon.

After the two-minute period has elapsed, the fault will reoccur if the Ribbon

Action remains set on FAULT (page 153). If the Ribbon Action is changed to

DISABLE or DISPLAY within the two-minute period, the fault will not reoccur.

If you do not want to change the ribbon at this time, you may disable

RibbonMinder. If the ribbon is worn, the “Change Ribbon” message will

reappear once the function is enabled again, and the printer status indicators

will flash until the ribbon is changed.

If the message display indicates the need to install a new ribbon and your

print job is one page short of completion, press CLEAR and then ON LINE to

print the last page. Otherwise, you may continue your print job at the end of

this procedure. The fault will occur again two minutes after clearing the fault.

NOTE: If the fault message appears on the control panel and the ribbon is

changed, the display will automatically reset to 100%. This feature

may be disabled through the Fault Action menu.

1 2 ... 149 150 151 152 153 154 155 156 157 158 159 ... 185 186

Sem comentários

Digital LG plus Series Guia de Configuração Página 154