Digital LG plus Series Manual de Instruções descarregar pdf (Página 141)

5–37

Replacement Procedures and

Illustrated Parts List

Ribbon Guide Assembly (L/R)

NOTE: The right ribbon guide is shown in Figure 5–15. The

removal/installation procedure is the same for both ribbon guides.

Removal

1. Prepare the printer for maintenance (page 4–2).

2. Remove the printer ribbon.

3. Cut and remove the tie–wrap from the tie wrap hole to free the ribbon

guide cable (page 5–69, Figure 5–15).

4. Remove the paper path (page 5–29).

5. Trace the ribbon guide cable back to the controller board, releasing it

from the cable restraints. (See cable routing diagram on page A–10.)

6. For the left ribbon guide, disconnect connector shell P106 from the

controller board. For the right ribbon cable, disconnect connector shell

P107 from the controller board.

7. Trace the ribbon guide wires to the connector shell, and remove the cable

connector from the connector shell (page 5–8).

8. Remove the two 7/32 inch screws and washers securing the ribbon guide

assembly to the side plate.

9. Slide the ribbon guide assembly out of the side plate.

Installation

1. Reverse steps 3 through 9 of the removal procedure above.

2. Align the ribbon guides (page 4–16).

3. Return the printer to normal operation (page 4–3).

1 2 ... 136 137 138 139 140 141 142 143 144 145 146 ... 249 250

Sem comentários

Digital LG plus Series Manual de Instruções Página 141