Digital LG plus Series Manual de Instruções descarregar pdf (Página 148)

5–44

Replacement Procedures and

Illustrated Parts List

Spring Assembly, Gas

NOTE: Two persons may be required to perform this procedure. Prop or

hold the printer cover securely while removing or installing the gas

spring assembly.

Removal

1. Prepare the printer for maintenance (page 4–2).

2. Open the printer cover.

3. Open the floor cabinet rear door.

4. Pry back the spring retaining clips (page 5–57, Figure 5–9).

5. Remove the gas spring assembly from the ball studs.

Installation

CAUTION

The gas spring assembly must be installed with the gas cylinder in the up

position.

1. Position the gas spring assembly against the ball studs on the upper and

lower brackets (page 5–57, Figure 5–9). The large cylinder must be

uppermost.

2. Using external grip ring pliers to spread the retaining clips, push the gas

spring assembly onto the ball joints and slide the spring clips over the top

(bottom) of the ball joint into the retaining grooves.

3. Close the printer cover. If necessary, adjust the position of the ball joint

stud in the lower bracket to achieve smooth and complete closure.

4. Return the printer to normal operation (page 4–3).

1 2 ... 143 144 145 146 147 148 149 150 151 152 153 ... 249 250

Sem comentários

Digital LG plus Series Manual de Instruções Página 148